Outils
- Gloves
- Flashlight
- Documented hand tools
Replace an owner-serviceable exterior bulb
Replace only a bulb the owner manual identifies as serviceable without removing safety-critical assemblies.
20–60 min3 outilselectrical
Pièces et fournitures
- Exact bulb type and wattage
Avant de commencer
- The lamp is confirmed owner-serviceable
- Circuit is off and lamp is cool
Une étape à la fois
Les vues réalistes montrent le composant et le geste de chaque étape. La disposition exacte varie selon le véhicule; confirmez toujours l’accès dans le manuel applicable.
ÉTAPE 1
Confirm the failed function
Check the exact lamp function, opposite side and relevant warning before buying a bulb.
Point de contrôleThe fault is not a whole-circuit, connector or control problem.
ÉTAPE 2
Open documented access
Switch lighting off and use only the access cover and removal direction in the owner manual.
Point de contrôleNo bumper, airbag, HV or sealed assembly is disturbed.
ÉTAPE 3
Install the exact bulb
Release the connector and retainer, keep glass clean, align tabs and lock the replacement without force.
Point de contrôleSeal, retainer and connector are fully seated.
ÉTAPE 4
Test and aim boundary
Test every affected function. If an assembly was moved or beam aim changed, arrange proper aiming.
Point de contrôleNo condensation, flicker or warning remains.
Vérification après réparation
- Correct brightness and function
- Access cover seals
- Beam aim remains safe