Outils
- Towel or windshield protector
- Optional small flat trim tool if the blade maker permits it
Replace windshield wiper blades
Replace worn blades without allowing the spring-loaded arm to strike the glass.
10–20 min2 outilsbody
Pièces et fournitures
- Correct-length, correct-connector wiper blades
Avant de commencer
- Correct blade sizes and connector type are confirmed
- Wipers are switched off and parked
Une étape à la fois
Les vues réalistes montrent le composant et le geste de chaque étape. La disposition exacte varie selon le véhicule; confirmez toujours l’accès dans le manuel applicable.
ÉTAPE 1
Protect the windshield
Place a folded towel on the glass beneath the arm and lift only as far as the vehicle permits.
Point de contrôleThe arm is supported and cannot snap onto bare glass.
ÉTAPE 2
Release the old blade
Rotate the blade and operate its documented tab or latch while supporting the arm.
Point de contrôleThe blade slides free without bending the arm.
ÉTAPE 3
Install the adapter
Match the new blade adapter to the arm and slide or rotate it until the latch clicks.
Point de contrôleA gentle pull does not release the blade.
ÉTAPE 4
Lower and test
Lower the arm gently, wet the glass with washer fluid and test at low speed.
Point de contrôleThe blade clears smoothly without striking trim or another blade.
Vérification après réparation
- Both blades lock securely
- No skipped area, chatter or collision
- Washer and park functions work